Cutting edge Airmen perform maintenance
Sheet metal scraps are scattered around a lathe machine after a piece of aluminum is milled down to size Aug. 7, 2013, at Joint Base Charleston, S.C. Airmen from the aircraft metals fabrication shop are trained to use several different pieces of equipment to bend, cut and combine metals. (U.S. Air Force photo/Senior Airman Dennis Sloan)
PHOTO BY:
Unknown
VIRIN:
130807-F-LR006-050.JPG
FULL SIZE:
9.28 MB
CAMERA
N/A
LENS
N/A
APERTURE
N/A
No camera details available.
IMAGE IS PUBLIC DOMAIN
Read More
This photograph is considered public domain and has been cleared for release.
If you would like to republish please give the photographer appropriate credit.
Further, any commercial or non-commercial use of this photograph or any other
DoD image must be made in compliance with guidance found at
https://www.dimoc.mil/resources/limitations,
which pertains to intellectual property restrictions (e.g., copyright and
trademark, including the use of official emblems, insignia, names and slogans), warnings
regarding use of images of identifiable personnel, appearance of endorsement, and related matters.